HP LH4r HP Netserver Service Handbook, Volume 2 - Mid - Page 96
This cable must be routed through the rear, access hole located below the controller board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Non-duplex, disk array model with PCI controller board (standard model) or EISA controller board Flexible Disk External terminator T built into cable Drive CD-ROM IDE SCSI or IDE Device System Board Internal terminator PCI/EISA Board built into I2C board SCSI B SCSI A C2 C6 T C4 Hot Swap Subsystem This cable must be routed through the rear access hole located below the controller board Off On UPPER CAGE 1 SCSI ID 2 3 ID ID ID 4 1 0 3 5 6 UPPER CAGE LOWER CAGE 1 2 3 4 5 6 ID ID ID 4 5 6 LOWER CAGE Default Switch Settings These are the default SCSI address settings for this model. SCSI ID 2 is reserved for an added DAT (Digital Audio Tape) drive that can be installed in the upper horizontal Shelf 3. The CD-ROM drive is set for SCSI ID 5. 88
88
Non-duplex, disk array model with PCI controller board (standard model) or EISA controller board
Hot Swap
Subsystem
SCSI or IDE
Device
CD-ROM
PCI/EISA Board
T
Flexible Disk
Drive
T
External terminator
built into cable
Internal
terminator
built into
board
System Board
IDE
SCSI A
SCSI B
IC
2
C6
C4
C2
This cable must be routed through the rear
access hole located below the controller board
UPPER
CAGE
1
2
3
4
5
6
LOWER
CAGE
1
2
3
4
5
6
6
5
4
1
0
3
SCSI ID
UPPER CAGE
LOWER CAGE
ID
ID
ID
ID
ID
ID
Off
On
Default Switch Settings
These are the default SCSI address settings for this
model. SCSI ID 2 is reserved for an added DAT (Digital
Audio Tape) drive that can be installed in the upper
horizontal Shelf 3. The CD-ROM drive is set for SCSI ID
5.