HP LH4r HP Netserver Service Handbook, Volume 2 - Mid - Page 91
System Board Switch SW1, Switch, Function, Default, FLASH WRITE ENABLE, BOOT BLOCK DISABLE, CONFIG
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
System Board Switch SW1 SW1 Default Settings: Switch 1 2 3 4 5 6 Off On 1 Flash Write Enable 2 Boot Lock Disable 3 Config Valid 4 Config Unlock 5 Password Enable 6 NMI LOG Enable 7 IO Control Enable 8 Video Enable LH Plus / LH Pro Off On 1 2 3 4 5 6 7 8 LH Flash Write Enable Boot Lock Disable Config Valid Config Unlock Password Enable SMI # Enable IO Control Enable Video Enable Function FLASH WRITE ENABLE: Enables or disables one of the two levels of flash ROM write protection (the other level of protection is controlled by the HP Update Utility). ON: The BIOS can be updated by the HP Update Utility. OFF: The BIOS is locked and cannot be updated. BOOT BLOCK DISABLE: Reserved. Must be set to ON for system to operate properly. CONFIG VALID: Saves or erases the current configuration information in NVRAM and CMOS. ON: Saves the current configuration. OFF: Erases the current system configuration. CONFIG UNLOCK: Prevents or allows the current system configuration maintained in NVRAM and CMOS to be changed. ON: Unlocked. Allows the current system configuration to be changed. OFF: Locked. Prevents the current system configuration from being changed. PASSWORD ENABLE: Enables or erases the power-on password maintained in NVRAM. ON: Power-on password functional. OFF: Erases the current power-on password. SMI# ENABLE: Not used; leave in the default position. Default ON ON ON ON ON OFF (LH) ON (LH Plus/Pro) 83