HP N7710 HP Scanjet N7710 Scanner Setup and Support Guide - Page 9
Connect the USB cable - power supply
UPC - 882780998599
View all HP N7710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3. Check that the green LED on the power supply cable connector is on. • If the green LED is not on, ensure that power is available to the power outlet or surge protector that the AC cable is plugged into. • If power is available to the power outlet or surge protector but the green LED is still not on, the power supply might be defective. Contact HP Support for assistance. 4. If the green LED is on, plug the power supply into the back of the scanner. English 5. Press the Power switch on the back of the scanner to the on position. Connect the USB cable CAUTION: Be sure you install the HP scanning software before connecting the scanner to your computer with the USB cable. See "Install the software" on page 3. Use the USB cable that came with the scanner to connect the scanner to the computer. Connect the square end of the cable to the scanner and the rectangular end of the cable to the computer. NOTE: HP recommends using a USB port on the back of the computer for a more reliable connection to the scanner. Set up the hardware 5