HP OMEN 15.6 Maintenance and Service Guide - Page 55
USB board, Remove the solid-state drives
View all HP OMEN 15.6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
NOTE: Use the same steps to remove each fan. 1. Disconnect the fan cable from the system board (1). 2. Remove the three Phillips M2.0 × 5.0 screws (2) that secure the fan to the computer. 3. Remove the fan from the computer (3). Reverse this procedure to install the fans. USB board To remove the USB board, use this procedure and illustration. Table 6-7 USB board description and part number Description USB board USB board cable Spare part number L98742-001 L98725-001 Before removing the USB board, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 31). 2. Remove the bottom cover (Bottom cover on page 31). 3. Remove the solid-state drives (Solid-state drive on page 32). 4. Remove the battery (see Battery on page 37). 5. Remove the heat sink (see Heat sink on page 41). 6. Remove the right fan (see Fans on page 44). Remove the USB board: Component replacement procedures 45