HP Photosmart R607 HP Photosmart R507/R607 digital camera with HP Instant Shar - Page 112
Resetting the Camera
View all HP Photosmart R607 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Resetting the Camera If your camera does not respond when you press any buttons, try resetting the camera as follows: 1 Holding the camera upside down with the front of the camera facing you, open the Battery/Memory card door on the bottom of the camera. 2 If you have an optional memory card installed, remove it. (Although removing an optional memory card is not necessary for performing the reset, it eliminates the memory card as a possible cause of the problem.) 3 Remove the battery from the camera, and make sure the HP AC power adapter is not connected to the camera. 4 The Reset switch is the small hole located above the battery slot, as shown. Press the straightened end of a paper clip into the Reset switch until the switch is depressed, and hold it down for approximately five seconds, then remove the paper clip. The camera is now reset. 5 Reinsert the battery and the optional memory card (if you have one) and close the Battery/Memory card door. You may now use the camera again. 112 HP Photosmart R507/R607 User's Manual