HP ProLiant DL160se HP ProLiant DL160se G6 Server Maintenance and Service Guid - Page 52
Lift the hard drive from the carrier., Loosen the four screws on the carrier two on each side.
![]() |
View all HP ProLiant DL160se manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Figure 19 Loosening the Screw 3. Push the hard drive toward the front of the unit 4. Pull the hard drive assembly out of the drive bay. Figure 20 Removing the Non-hot-plug Hard Drive Assembly To remove a non-hot-plug hard drive disk from the carrier: 1. Loosen the four screws on the carrier (two on each side). 2. Lift the hard drive from the carrier. Removal and replacement procedures 52
![](/manual_guide/products/hewlettpackard-proliant-dl160se-hp-proliant-dl160se-g6-server-maintenance-service-guide-08d2859/52.png)
Removal and replacement procedures
52
Figure 19
Loosening the Screw
3.
Push the hard drive toward the front of the unit
4.
Pull the hard drive assembly out of the drive bay.
Figure 20
Removing the Non-hot-plug Hard Drive Assembly
To remove a non-hot-plug hard drive disk from the carrier:
1.
Loosen the four screws on the carrier (two on each side).
2.
Lift the hard drive from the carrier.