HP ProLiant DL160se HP ProLiant DL160se G6 Server Maintenance and Service Guid - Page 92
Removal and replacement procedures, Loosening the Two Screws beneath the Chassis
![]() |
View all HP ProLiant DL160se manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
To remove the non-hot-plug power supply: 1. Loosen the two screws that secure the power supply, which are located beneath the chassis. Figure 83 Loosening the Two Screws beneath the Chassis 2. Loosen the screws that secure the power supply to the chassis. 3. Pull and lift the power supply out of the chassis. Figure 84 Removing the Non-hot-plug Power Supply To reinstall the non-hot-plug power supply: 1. Locate and push the power supply to the proper place in the chassis. 2. Fasten the power supply to the chassis using the screws as shown in the figure below. Removal and replacement procedures 92
![](/manual_guide/products/hewlettpackard-proliant-dl160se-hp-proliant-dl160se-g6-server-maintenance-service-guide-08d2859/92.png)
Removal and replacement procedures
92
To remove the non-hot-plug power supply:
1.
Loosen the two screws that secure the power supply, which are located beneath the chassis.
Figure 83
Loosening the Two Screws beneath the Chassis
2.
Loosen the screws that secure the power supply to the chassis.
3.
Pull and lift the power supply out of the chassis.
Figure 84
Removing the Non-hot-plug Power Supply
To reinstall the non-hot-plug power supply:
1.
Locate and push the power supply to the proper place in the chassis.
2.
Fasten the power supply to the chassis using the screws as shown in the figure below.