HP ProLiant DL160se HP ProLiant DL160se G6 Server Maintenance and Service Guid - Page 75
PCI cage, Installing PCIe/PCI-X riser cards, Full-Height/Full-Length
![]() |
View all HP ProLiant DL160se manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
PCI cage To remove the PCI cage: NOTE: Disconnect all cables connecting an existing expansion board to the system board. 1. Loosen the four screws that secure the PCI cage to the system board tray. 2. Lift the PCI cage away from the system board assembly. Figure 53 Removing the PCI Cage Installing PCIe/PCI-X riser cards The system supports up to two riser cards at a time. Use only HP supported expansion boards that meet the following specifications: • Compliance ○ PCIe x16 ○ PCI-X (available only when the optional PCI-X riser card is installed) • Form Factor ○ Low Profile ○ Full-Height/Full-Length To remove the PCIe riser card: 1. Loosen the two screws securing the riser card to the PCI cage. 2. Remove the riser card from the PCI cage. Removal and replacement procedures 75
![](/manual_guide/products/hewlettpackard-proliant-dl160se-hp-proliant-dl160se-g6-server-maintenance-service-guide-08d2859/75.png)