HP ProLiant DL380 ProLiant DL380 Generation 2 Server Maintenance and Service G - Page 27
Tape Drive Blank, Hot-Plug SCSI Hard
View all HP ProLiant DL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Removal and Replacement Procedures Tape Drive Blank To remove the tape drive blank: 1. Remove the hot-plug SCSI hard drive or hard drive blank in the bay below the tape drive blank: a. If a hot-plug SCSI hard drive is installed in the bay, see the "Hot-Plug SCSI Hard Drive" section in this chapter. b. If a hard drive blank is installed in the bay, see the "Hard Drive Blank" section in this chapter. 2. Squeeze the middle of the tape drive blank . 3. Pull to remove the blank . 1 2 Figure 2-8: Removing the tape drive blank CAUTION: Always populate the tape drive bay with either a tape drive or hard drive blank and tape drive blank. Operating the server without installing a tape drive or blank results in improper airflow and improper cooling that can lead to thermal damage. To replace the tape drive blank, slide the blank into the bay until it locks into place. Compaq ProLiant DL380 Generation2 Server Maintenance and Service Guide 2-13 COMPAQ CONFIDENTIAL Codename: Magna Part Number: 203840-003 Last Saved On: 1/28/02 1:12 PM