HP ProLiant DL380 ProLiant DL380 Generation 2 Server Maintenance and Service G - Page 50
PCI Riser Cage, Loosening the PCI riser cage thumbscrews
![]() |
View all HP ProLiant DL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Removal and Replacement Procedures PCI Riser Cage CAUTION: To avoid the risk of damage to your system or expansion boards, remove all AC power cords before installing or removing non-hot-plug expansion boards. Moving the Power On/Standby button to the standby position still provides auxiliary power to the PCI expansion slot and may damage the board or other system components. To remove the PCI riser cage: 1. Power down the server. See the "Powering Down the Server" section in this chapter. 2. Disconnect any external cables connected to expansion boards. 3. Extend or remove the server from the rack. See the "Preparation Procedures" section in this chapter. 4. Remove the access panel. See the "Access Panel" section in this chapter. 5. Disconnect the long SCSI cable from any array controller PCI expansion board, if installed. 6. Pull up the thumbscrew knobs . 7. Loosen both thumbscrews by turning them counterclockwise . 1 2 1 2 Figure 2-31: Loosening the PCI riser cage thumbscrews 2-36 Compaq ProLiant DL380 Generation2 Server Maintenance and Service Guide COMPAQ CONFIDENTIAL Codename: Magna Part Number: 203840-003 Last Saved On: 1/28/02 1:12 PM
![](/manual_guide/products/hewlettpackard-proliant-dl380-proliant-dl380-generation-2-server-maintenance-service-guide-4a8d3bc/50.png)