HP ProLiant DL380 ProLiant DL380 Generation 2 Server Maintenance and Service G - Page 48
Front Fan Bracket, Removing the front fan bracket
View all HP ProLiant DL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Removal and Replacement Procedures Front Fan Bracket To remove the front fan bracket: 1. Power down the server. See the "Powering Down the Server" section in this chapter. 2. Extend or remove the server from the rack. See the "Preparation Procedures" section in this chapter. 3. Remove the access panel. See the "Access Panel" section in this chapter. 4. Remove all the hot-plug fans in the bracket. See the "Hot-Plug Fan" section in this chapter. 5. Press inward on the release levers . 6. Lift the bracket . 2 1 1 Figure 2-29: Removing the front fan bracket IMPORTANT: Tighten the system board thumbscrew before installing the front fan bracket. The fan bracket does not seat securely if the thumbscrew is not fully tightened. Reverse steps 1 through 6 to replace the front fan bracket. 2-34 Compaq ProLiant DL380 Generation2 Server Maintenance and Service Guide COMPAQ CONFIDENTIAL Codename: Magna Part Number: 203840-003 Last Saved On: 1/28/02 1:12 PM