HP ProLiant DL380 ProLiant DL380 Generation 2 Server Maintenance and Service G - Page 49
SCSI Backplane, Removing the SCSI backplane
View all HP ProLiant DL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Removal and Replacement Procedures SCSI Backplane To remove the SCSI backplane: 1. Power down the server. See the "Powering Down the Server" section in this chapter. 2. Extend or remove the server from the rack. See the "Preparation Procedures" section in this chapter. 3. Remove the access panel. See the "Access Panel" section in this chapter. 4. Remove any hot-plug SCSI hard drives. See the "Hot-Plug SCSI Hard Drive" section in this chapter. 5. Remove the tape drive, if installed. See the "Universal Hot-Plug Tape Drive" section in this chapter. 6. Remove all hot-plug fans from the front fan bracket. See the "Hot-Plug Fan" section in this chapter. 7. Remove the front fan bracket. See the "Front Fan Bracket" section in this chapter. 8. Disconnect any cables connected to the SCSI backplane. 9. Loosen the two SCSI backplane thumbscrews . 10. Lift the SCSI backplane . 2 1 1 Figure 2-30: Removing the SCSI backplane Reverse steps 1 through 10 to replace the SCSI backplane. Compaq ProLiant DL380 Generation2 Server Maintenance and Service Guide 2-35 COMPAQ CONFIDENTIAL Codename: Magna Part Number: 203840-003 Last Saved On: 1/28/02 1:12 PM