HP ProLiant DL380 ProLiant DL380 Generation 2 Server Maintenance and Service G - Page 54
PCI Expansion Board Ejector/Divider,
View all HP ProLiant DL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Removal and Replacement Procedures PCI Expansion Board Ejector/Divider To remove the expansion board ejector/divider: 1. Power down the server. See the "Powering Down the Server" section in this chapter. 2. Extend or remove the server from the rack. See the "Preparation Procedures" section in this chapter. 3. Remove the access panel. See the "Access Panel" section in this chapter. 4. Remove the PCI riser cage. See the "PCI Riser Cage" section in this chapter. 5. Remove the three Torx T-15 screws that secure the expansion board ejector/divider . 6. Slide the expansion board ejector/divider toward the rear of the cage . This action dislodges the front tabs of the ejector/divider from the front of the cage. 7. Remove the expansion board ejector/divider from the cage . 3 1 1 2 1 Figure 2-35: Removing the PCI expansion board ejector/divider Reverse steps 1 through 7 to replace the PCI expansion board ejector/divider. 2-40 Compaq ProLiant DL380 Generation2 Server Maintenance and Service Guide COMPAQ CONFIDENTIAL Codename: Magna Part Number: 203840-003 Last Saved On: 1/28/02 1:12 PM