HP StorageWorks 2/64 HP StorageWorks Core Switch 2/64 and SAN Director 2/128 I - Page 30
Installing the switch as a stand-alone unit, Removing the chassis door
![]() |
View all HP StorageWorks 2/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Two jumper cables (C19-C20) are provided to connect from the switch to the PDU. The recommended power cords to connect from the PDU to the wall are E7803A, E7805A, E7806A, E7808A, and E7809A. Installing the switch as a stand-alone unit The following items are required for this setup: • Core Switch 2/64 or SAN Director 2/128 • AC power cords and cables supplied with the switch Removing the chassis door CAUTION: You must remove the chassis door before lifting the chassis off the pallet. (See Figure 4 for an illustration of the complete chassis door removal sequence.) 1. Open the door to a 90° angle. 2. Push the spring-loaded lever on the upper hinge up and into the notch in the hinge. 3. Push the spring-loaded lever on the lower hinge down and into the notch in the hinge, while supporting the door to prevent it from falling. 1 2 Figure 4 Sequence for detaching the chassis door from the hinges 3 SHR-2508A 30 Installing and configuring the switch
![](/manual_guide/products/hewlettpackard-storageworks-2128-hp-storageworks-core-switch-264-san-director-2128-installation-guide-aarvuscte-2005-46fb4cd/30.png)