HP StorageWorks 2/64 HP StorageWorks Core Switch 2/64 and SAN Director 2/128 I - Page 47
Manage cables
View all HP StorageWorks 2/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
8. Modify passwords, if desired. Passwords can be 8 to 40 characters long and should include a combination of numbers and upper/lowercase letters. To skip modifying the password, press Ctrl-C. Example: Fabric OS (swDir) swDir login: admin Password: Please change your passwords now. Use Control-C to exit or press 'Enter' key to proceed. Password was not changed. Will prompt again at next login until password is changed. swDir:admin> 9. Check the Active CP LED on the CP cards in slots 5 and 6 (see Figure 11), or enter the haShow command to verify which CP card is active. The configuration can be modified only through a login session to the active CP card. Example: swDir: admin> haShow Local CP (Slot 6, CP1): Active Remote CP (Slot 5, CP0): Standby HA Enabled, Heartbeat Up, State Synchronized Manage cables The SAN Director 2/128 cables can be managed in a variety of ways, including the routing them, as follows: • Through the cable management tray • Out either side of the chassis • Through patch panels or cable channels on the sides of the rack Core Switch 2/64 and SAN Director 2/128 installation guide 47