HP StorageWorks 7410 HP StorageWorks Virtual Array va 7000 family - Installati - Page 22
Step 6. Power-on the array controller enclosure, Operating the Power/Standby Switch
![]() |
View all HP StorageWorks 7410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Step 6. Power-on the array controller enclosure a Push in the power/standby switch to the "ON" position. See Figure 11. Immediately after the array is powered on, each component in the array enclosure performs a power-on self-test. b Verify the power-on self-test passed: all LEDs should be solid green. During power-on self-test, the an initialization sequence is displayed followed by the Ready prompt. If the array does not display a Ready status, see "Solving Installation Problems" on page 48 for help in solving the problem. Figure 11 Operating the Power/Standby Switch 22 Virtual Array Installation Guide
![](/manual_guide/products/hewlettpackard-storageworks-7110-hp-storageworks-virtual-array-va-7000-family-installation-guide-86beb6d/22.png)
22
Virtual Array Installation Guide
Step 6. Power-on the array controller enclosure
a
Push in the power/standby switch to the “ON” position. See Figure 11.
Immediately after the array is powered on, each component in the
array enclosure performs a power-on self-test.
b
Verify the power-on self-test passed: all LEDs should be solid green.
During power-on self-test, the an initialization sequence is displayed
followed by the Ready prompt.
If the array does not display a Ready status, see
"Solving Installation
Problems" on page 48
for help in solving the problem.
Figure 11
Operating the Power/Standby Switch