HP StorageWorks 7410 HP StorageWorks Virtual Array va 7000 family - Installati - Page 5
contents, Virtual Array Installation Guide
![]() |
View all HP StorageWorks 7410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
contents 1 Virtual Array Installation Guide 7 Other Information You Will Need 7 Operating Environment 8 Virtual Array Configurations 8 Virtual Array Enclosures 8 Hardware Installation 15 Step 1. Unpack the array 15 Step 2. Rack the array 15 Step 3. Set FC Loop Speed Switch (VA 7400 with DS 2405 Disk System) 16 Step 4. Connect the power cords 19 Step 5. Connect the RS-232 terminal 20 Step 6. Power-on the array controller enclosure 22 Configuring the Array Operating Settings 24 Step 7. Change the controller default host port behavior 25 Step 8. Change the controller port data rate to 2 Gbit/sec 25 Step 9. Change the controller port topology 26 Step 10. Change the controller loop ID 26 Step 11. Change the RAID operating level of the array 26 Step 12. Format the array controller enclosure 27 Step 13. Power-off the array controller enclosure 27 Step 14. Disconnect the RS-232 terminal 27 Step 15. Connect fiber optic cables 27 Step 16. Power-on all array enclosures 34 Installing CommandView SDM Software 35 Step 17. Install CommandView SDM software 35 Installing Command View SDM on HP-UX 37 Minimum System Requirements for HP-UX 37 Installation Steps 38 Installing Command View SDM on Windows 40 5
![](/manual_guide/products/hewlettpackard-storageworks-7110-hp-storageworks-virtual-array-va-7000-family-installation-guide-86beb6d/5.png)