HP StorageWorks 7410 HP StorageWorks Virtual Array va 7000 family - Installati - Page 42

Installing Command View SDM on Linux Red Hat Minimum System Requirements for Linux Red Hat Host ■ Red Hat Linux 7.1 with kernel 2.4.2 (plus patches, see web site mentioned below) ■ Intel Pentium III 500 MHz processor ■ RAM: 256 Mbyte ■ Video Resolution: 800x600 (for GUI) (Recommended 1024 X 768) ■ Video Support: 64K colors or better ■ Disk Space for Logs: 16 Mbyte per 2 months ■ Disk Space: 60 Mbyte Where to Get the Latest Linux Information For the most current supported Linux Kernel version and required patches for CommandView SDM, refer to the web documents, "Kernel Configuration" and "Linux Tips". These documents and all the latest information can be found in the Using Your Product section of the following HP support web site: http://www.hp.com/support/cvsdm Installation Tips. - For the latest software updates, refer to the README file on the HP StorageWorks CommandView SDM CD. The README is located in the corresponding operating system directory. - Before installing CommandView SDM, verify that the timezone system environmental variable, TZ, is properly set. If the TZ variable is not properly set before installation, the system logs may have inconsistent date stamps. If this should occur, set the TZ variable, then stop and restart HostAgent. 42 Virtual Array Installation Guide