HP mt20 Administrator Guide - Page 135
Display, as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below.
View all HP mt20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Registry key root/Dashboard/GUI/TaskBar root/Dashboard/General/AlwaysOnTop root/Dashboard/General/AutoHide root/Dashboard/General/EnterLeaveTimeout root/Dashboard/General/IconSize root/Dashboard/General/Length root/Dashboard/General/LengthToScreenSide root/Dashboard/General/PanelDockSide root/Dashboard/General/RemainPixel root/Dashboard/General/SlidingTimeout root/Dashboard/General/Width Description If set to 1, the application area is shown on the taskbar. If set to 1, the taskbar will always be on top. If set to 1, the taskbar auto-hides. Sets the amount of time in milliseconds before the taskbar will hide or show when AutoHide is enabled. Sets the size of the icons on the taskbar. Sets the length of the taskbar. If set to 1, the length of taskbar is fixed and equal to the length of the side of the screen to which it is anchored. Sets the side of the screen to which the taskbar is docked. Sets the number of pixels that are still visible when the taskbar hides. Sets the amount of time in milliseconds that it takes for the taskbar to hide or show when AutoHide is enabled. Sets the width of the taskbar. Display Registry key Description root/Display/Configuration/Hotplug/ newMonitorPosition On supported platforms, sets where new monitors should be placed (either to the left or right of currently attached monitors) when they are hotplug connected. root/Display/Configuration/displaymode Sets the display mode. If set to 0, the standard mode (a 1-4 monitor configuration) is used. If set to 1, a 6-monitor configuration can be used, but only on supported platforms with the appropriate add-on card. root/Display/Configuration/hexlayout Sets the layout in 6-monitor mode. root/Display/Configuration/hexprofile Sets the profile used in 6-monitor mode. root/Display/Configuration/primaryprofile Sets the profile to use for the primary monitor via the profile name. For Smart Zero, this must always be set to default. root/Display/Configuration/quaternarymode Sets the position of the fourth monitor relative to the monitor indicated in quaternaryrelative. This is hardware- dependent and is not supported on all models. Values are defined as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below. root/Display/Configuration/quaternaryprofile Sets the profile to use for the fourth monitor via the profile name. root/Display/Configuration/quaternaryrelative Sets which monitor is used as a reference to set the position of the fourth monitor. root/Display/Configuration/secondaryConnector Sets the secondary connector. root/Display/Configuration/secondarymode Sets the position of the secondary monitor relative to the primary monitor. This is hardware-dependent and is not supported on all models. Values are defined as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below. Display 123