Hitachi C8FSE Instruction Manual - Page 14

English 8mm Depth adjustment bolt Hinge (1) Turn the 8 mm depth adjustment bolt, change the height where the bolt head and the hinge contacts, and adjust the lower limit Gear case position of the saw blade. Saw blade NOTE: Confirm that the saw blade is adjusted so that it will not cut into the turntable. Hinge Fig. 10-a Turntable Turn 8mm Depth adjustment bolt Gear case Fig. 10-b 3. Lower limit position of saw blade when cutting a large workpiece NOTE: When cutting a workpiece exceeding 2-9/16" (65mm) in height in right-angle cutting or 1-25/32"(45mm) in left bevel angle cutting or 2-3/8" (60mm) in right bevel angle cutting, adjust the lower limit position so that the base of the motor head (see Fig. 10-a) will not come in contact with the workpiece. 6mm Depth adjustment bolt Hinge Turn To adjust the lower limit position of the saw blade, follow the procedure (1) shown in Fig. 11. (1) Lower the motor head, and turn the 6 mm depth adjustment bolt and make adjustments so that there can be a clearance of 5/64" to 1/8" (2 mm to 3 mm) between the lower limit position of the motor head and the top of the workpiece at the saw blade's lower limit position where the head of the 6 mm depth adjustment bolt contacts the hinge. Fig. 11 4. Confirmation for use of sub fence WARNING: In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is turned counterclockwise, the main body or saw blade may contact the sub fence, resulting in an injury. Right bevel This power tool is Equipped with a sub fence. Turn angle cutting In the case of right angle cutting and right bevel angle cutting, use Left bevel angle cutting Right angle cutting the sub fence. Then, you can realize stable cutting of the material with a wide back face. In the case of left bevel cutting, raise the sub fence up as illustrated in Fig. 12 and then turn it counterclockwise. Sub Fence Fence (B) Fig. 12 14