Hitachi C8FSE Instruction Manual - Page 22
Crown molding cutting procedures, For miter cut setting, For bevel cut setting, 30° and 33.9° left
UPC - 717709012998
View all Hitachi C8FSE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
English 10. Crown molding cutting procedures Fig. 33 shows two common crown molding types having angles of (θ) 38° and 45°. For the typical crown molding fittings, see Fig. 34. A upper surface Ceiling Ceiling Wall B lower surface Fig. 33 Wall 12 34 Inside corner Outside corner Fig. 34 The table below shows the miter angle and the bevel angle settings that are ideal for the two crown molding types. NOTE: For convenience, positive stops are provided for the miter setting (left and right 31.6°) positions. For miter cut setting If the turntable has been set to either of the angles described, move the turntable adjusting side handle a little to the right and left to stabilize the position and to properly align the miter angle scale and the tip of the indicator before the operation starts. For bevel cut setting Move handle on bevel section to the left and check that the position is stable and that the bevel angle scale and the tip of the indicator are properly aligned. Then tighten the clamp lever. Type of Crown Molding To process crown molding at positions 1 and 4 in Fig. 34. Miter Angle Setting Bevel Angle Setting To process crown molding at positions 2 and 3 in Fig. 34. Miter Angle Setting Bevel Angle Setting 45° Type right 35.3° ( mark) left 30° ( mark) left 35.3° ( mark) left 30° ( mark) 38° Type right 31.6° ( mark) left 33.9° ( mark) left 31.6° ( mark) left 33.9° ( mark) 30° and 33.9° left slant setting method Holder (A) Set pin Indicator (For bevel scale) Bevel Scale (1) Loosen the clamp lever and slant to the left a little at a time while pushing the set pin into the main unit. At this time, the fixing pin will enter one step and fit into the 30° left slant and 33.9° left slant setting slots. (2) With the set pin in the slot as described above, setting to the Clamp 30° left slant position is possible by pushing to the right side. lever (3) Also, with the set pin in the slot as described above, setting to the 33.9° left slant position is possible by pushing to the left side. Tighten Push (4) Look at the bevel scale and indicator to recheck whether or not Loosen the settings match and then tighten the clamp lever. Fig. 35 (1) Setting to cut crown moldings at positions 1 and 4 in Fig. 34 (see Fig. 36; tilt the motor head to the left): 1 Turn the turntable to the right and set the Miter Angle as follows: * For 45° type crown moldings: 35.3° ( mark) * For 38° type crown moldings: 31.6° ( mark) 2 Tilt the motor head to the left and set the Bevel Angle as follows: * For 45° type crown moldings: 30° ( mark) * For 38° type crown moldings: 33.9° ( mark) 3 Position the crown molding so that the upper surface (A in Fig. 33) contacts the fence as indicated in Fig. 38. 22