Hitachi DV18DMR Instruction Manual - Page 22

English G Store batteries out of the reach of children. G Use batteries correctly in accordance with the battery specifications and indications. 2. Using the bit holder CAUTION: G Stow the bit in the specified location on the tool. If Bit the tool is used with the bit stowed improperly, the bit may fall and cause bodily injury. G Do not stow bits that are of a different length, gauge or dimension than the plus driver bit (65 mm long) included in the STANDARD ACCESSORIES. The bit may fall and cause bodily injury. Fig. 16 (1) Removing the bit Securely hold the main unit and pull out the bit by holding the tip with your thumb. (Fig. 16) (2) Installing the Bit Install the bit with steps opposite of when removing. Insert the bit so that the right and left sides are equal, as shown in Fig. 17. 3. Installing/Removing the side handle CAUTION: G Firmly install the side handle. If loose, the side Concave handle may gyrate or fall out and cause bodily injury. (1) Install the side handle so that the protrusions on Side the main unit and grooves on the side handle handle interlock. Tighten the grip after checking that the side handle is not riding on the slip prevention protrusion. (Fig. 18) (2) Loosen the grip to remove the side handle. Loosen Insert so that bit does not protrude from main unit Fig. 17 Rotate preventing protrusion Slip preventing protrusion Tighten 4. Mounting and dismounting the bit (1) Mounting the bit Grip Fig. 18 Loosen Sleeve Loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the front) to open the clip on the keyless chuck. After inserting a driver bit, etc., into the keyless drill chuck, and tighten the sleeve by turning it toward the right (in the clockwise direction as viewed from the front). (See Fig. 19) Tighten Fig. 19 NOTE: If the sleeve becomes loose during operation, tighten it further. The tightening force becomes stronger when the sleeve is tightened. 22