Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste Installation Guid - Page 45

LYNXR-2 Series Installation and Setup Guide ✻81 Zone List Menu Mode While in Program mode, press ✻81 to enter Zone List Menu Mode. This mode is used to program zone lists for output devices (programmed in ✻80 Device Programming Menu Mode) or Chime-by-Zone in Zone List 3. The prompts for *81 are as follows: 81 Zone List Programming Main Menu prompt A 01 Zone List Number for entering the zone list number to be programmed b Zone Entry to List for entering zones to the assigned zone list C Delete Entire List for deleting the entire zone list and its contents d Delete Specific Zones From List?-------- Selects whether to delete zones or return to next zone list number E Delete Zones for deleting specific zones from the current zone list The following explains these prompts in detail. The left two columns identify the prompts and list the available entries. The right-most column provides a further explanation of the entries. Notes: (1) (2) (3) (4) (5) Any list may include any or all of the systems zone numbers A zone list can be assigned to more than one Powerline Carrier Device Entering a number other than one specified will give unpredictable results. Do not assign zones with zone types 20, 21 or 22 to a zone list. LYNXR-SIA ONLY Zone List 2 should be used for Cross Zoning. When creating zone list 2 for cross zoning, include only 2 zones assigned to zone types 3, 4, or 5. If interior zones (zone type 4) are cross zoned, then both zones in zone list 2 must be interior zones. Do not cross zone more than 2 zones, or zone types that have delays (entry/exit zones, interior w/delay), or 24-hour zones, as these choices may produce unpredictable operation and may not function as intended. If cross zoning is used, zone list 2 should not be used for other purposes, such as triggering powerline carrier devices. If field ✻39 has been set to "0" (no cross zoning), then Zone List 2 can be used for other purposes. - 45 -