Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste Installation Guid - Page 67

LYNXR-2 Series Installation and Setup Guide Troubleshooting Guide Control SYMPTOM POSSIBLE CAUSE 1. The word "AC" is not displayed. 1a. Interrupted AC power supply. 2. Digital communicator 2a. System in Test mode. message not being received. 2b. Telephone connection not secure. 2c. Digital communicator malfunctioning. 2d. Telephone number in program needs prefix or access code. 2e. Telephone call to central monitoring station requires operator assistance. 3. Does not arm properly. READY light not on. Open or faulted zone(s) 4. System doesn't respond to keystrokes on keypad. 4a. "CC" displayed. 4a. System is in communication with downloader at central station. 4b. "dI" displayed. 4b. System has just been powered and is in its one minute initialization. REMEDY 1a. Check transformer connection and powerline circuit breaker. 2a. Remove from Test mode. 2b. Check all connections. 2c. Check with a different CONTROL PANEL. 2d. Program prefix or access code into the CONTROL PANEL. 2e. System cannot work in this situation. Check for faulted zones and make intact, or use Bypass arming, if desired. 4a. Wait until download session is finished. 4b. Wait for initialization to finish, or bypass this time by pressing '#' + '0.' Smoke Detectors SYMPTOM 1. Detector alarms, no apparent reason. 2. Detector's siren sounds. POSSIBLE CAUSE 1a. Dust, dirt in sensing chamber. 1b. Improper location. 1c. Unit malfunctioning. 2a. Unit not receiving required power. 2b. Unit malfunctioning. REMEDY 1a. Clean unit's sensing chamber with vacuum cleaner per unit's instructions. 1b. See unit's instructions for locations to avoid. Relocate as necessary. 1c. Replace detector. 2a. Check for proper installation of battery. Try new battery. 2b. Replace detector. - 67 -