Husqvarna AUTOMOWER 435X AWD Owner Manual - Page 17

•

Use the park function or switch off the

product when persons, especially children or

pets, are in the work area. Refer to

To

switch off the product on page 38

. It is

recommended to program the product for

use during hours when the area is free from

activity, e.g. at night. Consider that certain

species, e.g. hedgehogs, are active at night.

They can potentially be harmed by the

product. Refer to

Schedule on page 31

.

•

Check that there are no foreign objects such

as stones, branches, tools or toys on the

lawn. If the blades hit foreign objects the

blades can be damaged. Always switch off

the product before clearing a blockage.

Inspect the product for damage before

staring the product again. Refer to

To switch

off the product on page 38

.

•

If the product starts to vibrate abnormally.

Always switch off the product and inspect for

damage before staring the product again.

Refer

To switch off the product on page 38

.

•

Switch on the product according to the

instructions. When the product is switched

on; make sure to keep your hands and feet

away from the rotating blades. Never put

your hands and feet under the product.

•

Never touch moving hazardous parts, such

as the blade disc, before it has come to a

complete stop.

•

Never lift up the product or carry it around

when it is switched on.

•

The product must never be allowed to

collide with persons or other living creatures.

If a person or other living creature comes in

the way of the product, it shall be stopped

immediately. Refer to

To stop the product on

page 38

.

•

Do not put anything on top of the product or

its charging station.

•

Do not allow the product to be used with a

defective guard, blade disc or body. Neither

should it be used with defective blades,

screws, nuts or cables. Never connect a

damaged cable, or touch a damaged cable

before it is disconnected from the supply.

•

Do not use the product if the

STOP

button

does not work.

•

Always switch off the product when it is not

in use. The product can only start when the

correct PIN code has been entered.

•

The product must never be used at the

same time as a sprinkler. Use the

Schedule

function so the product and sprinkler never

run simultaneously. Refer to

Schedule on

page 31

.

•

Husqvarna does not guarantee full

compatibility between the product and other

types of wireless systems such as remote

controls, radio transmitters, hearing loops,

underground electric animal fencing or

similar.

•

The built-in alarm is very loud. Be careful,

especially if the product is handled indoors.

•

Metal objects in the ground (for example

reinforced concrete or anti-mole nets) can

result in a stoppage. The metal objects can

cause interference with the loop signal

which then can lead to a stoppage.

•

Operation and storage temperature is 0-50

°C / 32-122 °F. Temperature range for

charging is 0-45 °C / 32-113 °F. Too high

temperatures might cause damage to the

product.

2.3.2 Battery safety

WARNING:

Lithium-ion batteries can

explode or cause fire if disassembled,

short-circuited, exposed to water, fire,

or high temperatures. Handle carefully,

do not dismantle, open the battery or

use any type of electrical/mechanical

abuse. Avoid storage in direct sunlight.

For more information about the battery, refer to

Battery on page 44

1404 - 002 -

Safety -

17

Section	Page
Contents	2
Introduction	3
Support	3
Product description	3
Mowing technique	3
Find the charging station	3
Automower® Access	3
Automower® Connect	3
Product overview	4
Symbols on the product	5
Symbols on the battery	6
General manual instructions	6
Automower® Access	6
Display	7
To operate Automower® Access	8
Menu structure overview in Automower® Access	9
Menu structure overview 1	11
Menu structure overview 2	12
Menu structure overview 3	13
LED status indicator	14
Safety	15
IMPORTANT. READ CAREFULLY BEFORE USE. KEEP FOR FUTURE REFERENCE	15
Safety definitions	16
Safety instructions for operation	16
Use	16
Battery safety	17
How to lift and move the product	18
Maintenance	18
In the event of a thunderstorm	19
Installation	20
Introduction - Installation	20
Main components for installation	20
General preparations	20
Before the installation of the wires	20
To examine where to put the charging station	20
To examine where to put the power supply	21
To examine where to put the boundary wire	21
To put the boundary wire in a slope	23
Passages	23
To make an island	23
To make a secondary area	24
To examine where to put the guide wire	25
Work area examples	25
Installation of the product	25
Installation tools	25
To install the charging station	26
To install the boundary wire	27
To install the guide wire	27
To put the wire into position with stakes	28
To bury the boundary wire or the guide wire	28
To extend the boundary wire or the guide wire	28
After the installation of the product	29
To do a visual check of the charging station	29
Automower® Connect	29
To install the Automower® Connect app	29
To pair Automower® Connect and the product	29
My mowers	29
Firmware over the air (FOTA)	29
To set the Firmware over the air (FOTA)	29
Automower® Direct	29
To start to use Automower® Direct	30
User interface overview	30
To start the product for the first time	30
Settings in Automower® Connect	31
Schedule	31
To edit the schedule settings	31
To add a new schedule setting	31
To calculate the schedule setting	31
Operation	32
Weather timer	32
To set the Weather timer	32
ECO mode	32
To set the ECO mode	32
Installation	32
To find the charging station	32
To change the signal range of the charging station	33
To set the delay time for the guide wire and the boundary wire	33
Lawn coverage	33
To set the GPS function	33
To set the Lawn Coverage function	33
To measure the distance from the charging station	34
To do a test of the Lawn Coverage function	34
Drive Past Wire	34
To set the Drive past wire	34
Starting point	34
To set the starting point	34
Accessories	34
Headlights	34
To set the headlight settings	34
To set the headlight to flash when fault	34
To avoid collisions with the mower house	35
General (Bluetooth® only)	35
Time & date	35
To set the time & date	35
Reset to factory settings	35
To reset to factory settings	35
Security (Bluetooth® only)	35
New loop signal	35
To create a New loop signal	35
To change the PIN code	35
Theft protection	35
Require PIN code	35
Alarm duration	35
STOP button pressed	35
Carried away	36
To set the Theft protection	36
GeoFence	36
To set the center position for the GeoFence function	36
Automower® Connect (Bluetooth® only)	36
Messages	36
Operation	37
To switch on the product	37
Operating modes	37
Main area	37
Secondary area (2nd area)	37
Park	37
Park until further notice	38
Park for a selected number of hours	38
To stop the product	38
To switch off the product	38
To charge the battery	38
To adjust the cutting height with Automower® Access	39
Maintenance	40
Introduction - maintenance	40
Clean the product	40
To clean the blade disc	40
Chassis	41
Wheels	41
The body of the product	41
Charging station	41
Replace the blades	41
To replace the blades	41
To replace the top covers	42
To remove the front top cover	42
To install the front top cover	42
To remove the rear top cover	43
To install the rear top cover	44
Battery	44
Winter service	45
Troubleshooting	46
Introduction - troubleshooting	46
Error icons in the Automower® Access display	46
Fault messages	47
Information messages	54
Indicator lamp in the charging station	55
Symptoms	56
Find breaks in the loop wire	57
Transportation, storage and disposal	60
Transportation	60
Storage	60
Disposal	60
To remove the battery	60
Technical data	62
Technical data	62
Registered trademarks	64
Warranty	65
Warranty terms	65
Applicable to US/CA market	66
Supplier's Declaration of Conformity	66

Husqvarna AUTOMOWER 435X AWD Owner Manual - Page 17

Battery safety, To switch off the product

Page 17 highlights