Husqvarna AUTOMOWER 435X AWD Owner Manual - Page 59
positions. Then switch AR and G1. If, indicator lamp now is lit with a solid green
![]() |
View all Husqvarna AUTOMOWER 435X AWD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
AR Continue until only a very short section of the wire remains which is the difference between a solid green light and a flashing blue light. Then follow instruction in step 5 below. 4. If indicator lamp still flashes blue in step 3 above: Put AL and G1 back in their original positions. Then switch AR and G1. If indicator lamp now is lit with a solid green light then disconnect AL and connect a new boundary wire to AL. Connect the other end of this new wire at the middle of the suspected wire section. Follow the same approach as in 3a) and 3b) above. 5. When the break is found, the damaged section must be replaced with a new wire. Always use original couplers. If the indicator lamp now is green, then the break is somewhere in the wire between the disconnected end to the point where the new wire is connected (thick black line below). In that case, move the connection for the new wire closer to the disconnected end (roughly at the middle of the suspected wire section) and check again if the indicator lamp is green. 1404 - 002 - Troubleshooting - 59
![](/manual_guide/products/husqvarna-automower-435x-awd-owner-manual-6066b37/59.png)