IBM 621858U Installation Guide - Page 44
Table, error, messages, continued, Problem, Determination, Service, Guide
UPC - 000435883148
View all IBM 621858U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Table 2. POST error messages (continued) v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See the part listing in the Problem Determination and Service Guide to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error codes Description Action 162 A change in the device configuration 1. Make sure that all external devices are occurred. This error occurs under one or turned on. You must turn on external more of the following conditions: devices before turning on the computer. v A new device has been installed. v A device has been moved to a different location or cable connection. v A device has been removed or disconnected from a cable. 2. If you did not add, remove, or change the location of a device, a device is probably failing. Running the diagnostic program might isolate the failing device. v A device is failing and is no longer (See "Starting the diagnostic programs recognized by the computer as being and viewing the test log" or "Using the installed. Enhanced Diagnostics Diskette or CD" in v An external device is not turned on. the Problem Determination and Service v An invalid checksum is detected in the Guide). battery-backed memory. 3. Run the Configuration/Setup Utility program, select Load Default Settings, and save the settings. 4. Reseat the following components: a. Battery b. Failing device 5. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Battery b. Failing device (if the device is a FRU, the device must be replaced by a trained service technician only). c. (Trained service technician only) System board 163 The time of day has not been set. 1. Run the Configuration/Setup Utility program, select Load Default Settings, make sure that the date and time are correct, and save the settings. 2. Reseat the battery. 3. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Battery b. (Trained service technician only) System board 32 IBM IntelliStation M Pro Type 6218: Installation Guide