IBM 621858U Installation Guide - Page 46
replaceable
![]() |
UPC - 000435883148
View all IBM 621858U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Table 2. POST error messages (continued) v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See the part listing in the Problem Determination and Service Guide to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error codes Description Action 289 An error occurred during POST memory 1. If you just installed memory, make sure tests and a DIMM was disabled. that the new memory is correct for the computer. 2. If the DIMM was disabled by the user, run the Configuration/Setup Utility program and enable the DIMM. 3. Reseat the DIMM. 4. Replace the DIMM. 301, and 303 An error occurred during the keyboard and keyboard controller test. These error messages may also be accompanied by continuous beeping. 1. If you have just connected a new mouse or other pointing device, turn off the computer and disconnect that device. Wait at least five seconds; then turn on the computer. If the error message goes away replace the device. 2. Make sure that nothing is resting on the keyboard or pressing on a key. 3. Make sure that no key is stuck. 4. Reseat the keyboard cable and make sure that it is connected to the correct connector on the computer. 5. After installing a USB keyboard, run the Configuration/Setup Utility program to enable keyboard-less operation, and prevent POST error messages from being displayed during startup. 6. Run the diagnostic tests to isolate the computer component that failed. 7. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Keyboard b. (Trained service technician only) System board. 602 An invalid diskette boot record error 1. Reseat the diskette drive cable. occurred. 2. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Diskette drive cable b. Diskette drive c. (Trained service technician only) System board 34 IBM IntelliStation M Pro Type 6218: Installation Guide
![](/manual_guide/products/ibm-621858u-installation-guide-dec32bd/46.png)