IBM 6862 User Guide - Page 59

Handling a CD When handling a CD, follow these guidelines: Hold the CD by its edges. Do not touch the surface. To remove dust or fingerprints, wipe the CD from the center to the outside. Wiping the CD in a circular direction might cause loss of data. Do not write or stick paper on the CD. Do not scratch or mark the CD. Do not place or store the CD in direct sunlight. Do not use benzene, thinners, or other cleaners to clean the CD. Do not drop or bend the CD. Loading a CD To load a disk into a CD-ROM drive: 1. Press the Eject/Load button. The tray slides out of the drive. (Do not manually force the tray open.) 2. Place the disk in the tray with the label facing up. 3. Close the tray by pressing the Eject/Load button, or by gently pushing the tray forward. When the tray is closed, the indicator light on the front of the drive will activate to indicate that the drive is in use. 4. To eject the disk, press the Eject/Load button. When the tray slides out, carefully remove the disk. 5. Close the tray by pressing the Eject/Load button, or by gently pushing the tray forward. Note: If the tray does not slide out of the drive when you press the Eject/Load button, insert the pointed end of a large paper clip into the emergency-eject hole located above and to the left of the CD-ROM indicator light. Chapter 4. Operating your computer 41