IBM 6862 User Guide - Page 61

To load a CD into a CD-ROM drive with a support wire: 1. Press the Eject/Load button. The tray slides out of the drive. (Do not manually force the tray open.) 2. Locate the wire that is installed in the right edge of the tray. 3. Gently flex the wire until you can remove each end from its socket. 4. Locate the two holes near the edge of the tray. (One hole is in the notch on the inner end of the tray, and the other is in a spring-tab at the outer end.) 5. Insert the wire into the inner hole first, then flex the wire until you can insert the other end of it into the spring-tab. When the wire is inserted correctly, it is parallel to the edge of the tray and approximately 20 mm (0.75 in.) in from the outside edge. 6. Because of the spring-tab, you can lift the support wire when you insert a CD and let it hold the CD in place. Close the tray by pressing the Eject/Load button, or by gently pushing the tray forward. When the tray is closed, the indicator light on the front of the drive will activate to indicate that the drive is in use. 7. To eject the CD, press the Eject/Load button. When the tray slides out, carefully remove the CD. (If the wire on the tray is extended, retract it to remove the CD.) 8. Close the tray by pressing the Eject/Load button, or by gently pushing the tray forward. Chapter 4. Operating your computer 43