IBM 6862 User Guide - Page 80

Starting and using the program To start the Configuration/Setup Utility program: 1. Turn on your computer. If your computer is already on when you start this procedure, you must shut down the operating system, turn off the computer, wait a few seconds until all in-use lights go off, and restart the computer. (Do not use Ctrl+Alt+Del to restart the computer.) 2. When the Configuration/Setup Utility program prompt appears in the lower left corner of the screen during startup, press F1. (The Configuration/Setup Utility program prompt appears on the screen for only a few seconds. You must press F1 quickly.) 3. If you have not set an administrator password, the Configuration/Setup Utility program menu appears on the screen. If you have set an administrator password, the Configuration/Setup Utility program menu will not appear until you type your administrator password at the password prompt and press Enter. See "Using a power-on password" on page 67 and "Using an administrator password" on page 71 for more information. The menu you see on your computer might look slightly different from the menu shown here, but it will operate the same way. Configuration/Setup Utility Select Option: System Summary Product Data Devices and I/O Ports Start Options Date and Time System Security Advanced Setup ISA Legacy Resources Power Management Save Settings Restore Settings Load Default Settings Exit Setup 62 Using Your Personal Computer