IBM 847691U Hardware Maintenance Manual - Page 162

266 MHz 12345678 ON OFF 300 MHz 12345678 ON OFF 350 MHz 12345678 ON OFF 400 MHz 12345678 ON OFF 450 MHz 12345678 ON OFF 500 MHz 12345678 ON OFF 550 MHz 12345678 ON OFF 600 MHz 12345678 ON OFF 650 MHz 12345678 ON OFF 700 MHz 12345678 ON OFF Table 7. Microprocessor Switch Settings 450MHz and Up All microprocessors of speed 450MHz and up will automatically set their internal speeds, so the switch setting is not applicable. 3. If you receive the error code 167 after you install a new microprocessor, run the Flash Utility program. Insert the Flash Utility Diskette into the primary diskette drive and reboot the system. Follow the instructions in the program. 4. After changing configuration switch settings, you must reconfigure the server. After reassembling the server (see "Completing the installation" on page 77), use the Configuration/Setup Utility program to reconfigure the server. For more information, see "Configuration/Setup utility program menus" on page 24. 154 Netfinity Server HMM