IBM 847691U Hardware Maintenance Manual - Page 197

Ethernet controller messages Note The following error messages are available only with the integrated Ethernet controller. These error messages are not available when remote program load (RPL) or dynamic host configuration protocol (DHCP) is used through optional network adapters. If a failure condition occurs after the Ethernet controller is initialized, one or more of the following error messages will be displayed on the screen. The two most common error messages are: RPL-ROM-ERR: 1 5 The integrated Ethernet failed the loopback test. RPL-ROM-ERR: 1 7 The media test failed. Error 105 indicates that a power-on diagnostic test performed by the Ethernet module did not execute correctly. If this error message appears, replace the system board. Error 107 indicates that the cable from the LAN is not securely connected to the Ethernet port on the server. Check the cable to ensure that it is properly connected. Other error messages that might occur are shown in Table 12 on page 190. Note An x value that follows an error code represents any alphanumeric character. IBM Netfinity 3000 - Type 8476 189