IBM 8480 Hardware Maintenance Manual - Page 106
Power-supply, errors
UPC - 087944878070
View all IBM 8480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Note: See "System" on page 112 to determine which components should be replaced by a field service technician. CD-ROM drive problems Symptom FRU/action System management test failed. 1. ASM adapter, if installed. 2. System board. CD0ROM test failed. 1. CD-ROM/diskette drive assembly. 2. System board. Ethernet test failed. v System board. ServeRAID test failed. v RAID controller. Tape drive test failed. v Tape drive. Power-supply LED errors Use the information in this section to solve power-supply problems. Note: The minimum configuration required for the dc good light to be lit is: v Power supply v Power cage assembly, if installed. v System board (set switch 7 of SW1 to bypass the power switch; see "System and PCI extender boards" on page 34. Note: See "System" on page 112 to determine which components should be replaced by a field service technician. AC good LED DC good LED Description FRU/action Off Off No power to system or ac problem. 1. Check ac power to the system. 2. Power supply. On Off Standby mode or dc problem. 1. Check system board cable connectors J4 and J10. Move switch 7 of SW 1 to bypass power control. If the dc good LED is lit, press Ctrl+Alt+Delete. Watch the screen for any POST errors. Check the System Error Log for any listed problems. If the system starts with no errors: a. Power switch assembly b. System board 2. Remove the adapters and disconnect the cables and power connectors to all internal and external devices. Turn on the system. If the dc good LED is lit, replace the adapters and devices one at a time until you isolate the problem. 3. Power supply. 4. Power cage assembly, if installed. 5. System board. On On Power is working properly. N/A 96 IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide