IBM 8480 Hardware Maintenance Manual - Page 92
Handle, assembly
UPC - 087944878070
View all IBM 8480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Handle assembly Note: v Read "Safety information" on page 119. v Read "System reliability considerations" on page 33. To remove the handle cap, complete the following steps: 1. Turn off the server, if it is on. 2. Unplug the server. 3. Use a flathead screwdriver to gently press in and down on the tabs located on the interior side wall of the handle. Tab locations 4. Lift up on the handle cap to separate it from the handle support. 5. Turn the system back to the tower-orientation; then, remove the top handle. a. Carefully use a flat-blade screwdriver to push in the tabs inside the plastic cover on the top of the system; then, remove the plastic cover. Store the cover for possible future use. b. Grasp the metal handle and slide it toward the rear of the system to remove it from your system. Store the metal handle for possible future use. To remove the handle support, complete the following steps: 1. Turn off the server, if it is on. 2. Unplug the server. 3. Firmly grasp the handle support and slide it away from the front bezel. 4. Lift up on the handle support to remove it from the slots in the top of the chassis. 82 IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide