IBM 865951Y Hardware Maintenance Manual - Page 79
To remove a drive in bay C, Insert the drive into the bay.
UPC - 087944501824
View all IBM 865951Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
To remove a drive in bay C: 1. Locate the drive-release tab on the diskette drive. 2. Press the tab against the drive and hold it there while pulling the drive out. 3. Disconnect the diskette drive cable and power cable from the drive. 4. If you want to install or remove any other options, do so now. Otherwise, go to "Completing the installation" on page 77. To install a drive in bay C: 1. If you have not done so, remove the server cover and front bezel. See "Option installation" on page 125. 2. Using the instructions that come with the drive, together with these instructions, check that any switches or jumpers on the drive are set correctly. Change the settings if necessary. For information about termination requirements, see "Termination requirements" on page 67. 3. Insert the drive into the bay. a. Position the drive so that the connectors face the rear of the server and the diskette eject button is toward the outside of the server. b. Connect the diskette drive cable and power cable to the drive. Note If you have difficulty connecting a cable, turn the cable connector over and try again; cable connectors are keyed to connect only one way. Netfinity 5000 - Type 8659 71