IBM 9114-275 Installation Guide - Page 42
Placing the Model 275 into the Service and Operating Position, Bezel Door, Bezel Door Removal
View all IBM 9114-275 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Placing the Model 275 into the Service and Operating Position The Model 275 can be placed on its side or left in an upright position with the side removed in order to work on the inside of the system unit. When finished working on the system, return it to the position in which it was placed for customer operations. Bezel Door The following procedure covers removal and replacement of the bezel door. Bezel Door Removal Refer to the following illustration while you perform the steps in this procedure. To remove the bezel door, do the following: 1. Open the bezel door by grasping the door handle. Swing the bezel door away from the system. 2. Lift the bezel door release tab located at the bottom of the door in order to clear the post. 3. Gently swivel the bottom of the door forward, out past the bottom of the system. 4. Pull the door down to remove the top retaining post from the bezel. 1 Model 275 2 System Handle Assembly Post Retaining Hole 3 Bezel Door Top Retaining Post 4 Bezel Door 5 Bezel Door Handle 6 Bezel Door Release Tab 7 Bezel Door Lower Retaining Post Bezel Door Replacement To replace the bezel door, do the following: 1. Place the top retaining post into the system handle assembly post retaining hole. See the preceding illustration. 2. Lift the door release tab and rotate the door onto the lower retaining post. 3. Rotate the bezel door toward the bottom of the system. 4. Close the bezel door. 26 IntelliStation POWER 9114 Model 275 Installation Guide