IBM 9114-275 Installation Guide - Page 64
Configuring (Replacing) a Disk Drive, Add a Physical Volume to a Volume Group
View all IBM 9114-275 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Configuring (Replacing) a Disk Drive To configure or replace a disk drive, do the following: 1. Remove the disk drive from its protective packaging, and open the drive latch handle. 2. Install the disk drive in the drive slot. Align the disk drive with the drive slot rails, and slide the disk drive into the slot until it contacts the backplane at the rear of the drive bay. The drive should be in far enough for the latch handle to engage the latch. Push the disk drive lever up and to the rear to lock the disk drive. The LED above the slot will turn on. 3. Log in as root user. 4. At the command line, type smitty. 5. Select Devices. 6. Select Install/Configure Devices Added After IPL and press Enter. Successful configuration is indicated by the OK message displayed next to the Command field at the top of the screen 7. Press the F3 key enough times to return to first smitty menu. Then select System Storage Management (Physical and Logical Storage). 8. Select Logical Volume Manager and press Enter. 9. Select Volume Groups and press Enter. 10. Select Set Characteristics of a Volume Group and press Enter. 11. Select Add a Physical Volume to a Volume Group. 12. Fill in the fields for the drive you are adding to the system. Press F4 for a list of selections. 13. See the AIX System Management Guide: Operating System and Devices to finish the drive configuration. Documentation for the AIX operating system is available from the IBM pSeries Information Eserver Center at http://publib16.boulder.ibm.com/pseries/en_US/infocenter/base. Select AIX documentation. The AIX Documentation CD contains the base set of publications for the operating system, including system-management and end-user documentation. 14. Press F10 to exit smitty. 48 IntelliStation POWER 9114 Model 275 Installation Guide