IBM 9114-275 Installation Guide - Page 56
Power Supply Replacement, Power supply, Fault LED Amber, Power supply handle latch, DC Good LED Green
![]() |
View all IBM 9114-275 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Power Supply Replacement Note: During normal operation, the secondary power-supply bay must have either a power supply or filler panel installed for proper cooling. To replace a power supply, do the following: 1. Grasp the handles located on top of the new power supply. Pivot the handles upward to 90 degrees. This action puts the handle cams into the correct position to help seat the power supply into its connector. 2. Carefully insert the new power supply into the power supply bay. 3. Lower the power supply release handles, carefully pressing the power supply into the connector. The spring latch located on the underside of each handle will snap into place, indicating that the power supply is seated correctly and locked into position. 1 Power supply 2 Power supply handle latch 3 Retractable spring-activated portion of the handle 4 Fault LED (Amber) 5 DC Good LED (Green) 6 AC Good LED (Green) 4. Plug the power cables into the back of the power supplies. Note: Do not connect the power cables to the power source until you are instructed to do so. 5. Replace the service access cover as described in "Service Access Cover Replacement" on page 28. 6. Reconnect the system unit to the power source. 7. Power on the system unit as described in "Starting the System" on page 25. 40 IntelliStation POWER 9114 Model 275 Installation Guide
![](/manual_guide/products/ibm-9114275-installation-guide-4bf8d2f/56.png)