IBM IC35L036UWDY10 Hard Drive Specifications - Page 103
LED Mode = 4h: Command Active/Degraded Mode, Temperature Threshold, Command Aging Limit
![]() |
UPC - 000004119524
View all IBM IC35L036UWDY10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
- LED Mode = 0h: CMDAC determines the behavior of LED. CMDAC is one: Command Active CMDAC is zero: Motor Active - LED Mode = 1h: Motor Active - LED Mode = 2h: Command Active - LED Mode = 3h: Degraded Mode - LED Mode = 4h: Command Active/Degraded Mode - LED Mode = other: Motor Active ! Temperature Threshold specifies the threshold value in degrees Celsius for the SMART warning for temperature. A value of 0 selects the default value (85 degrees Celsius). ! Command Aging Limit controls the maximum time that a command should wait in the command queue when the CAEN bit is set. Each unit of this timer is 50 ms. ! QPE Read Threshold specifies the additional ERP steps in addition to the default ERP steps before reporting recovered errors for read operations when QPE and PER (Mode Page 1) are set to one. The verify operations also use QPE Read Threshold. ! QPE Write Threshold specifies the additional ERP steps in addition to the default ERP steps before reporting recovered errors for write operations when QPE, PER (Mode Page 1) and RRNDE are set to one. ! DRRT (Disable Restore Reassign Target) of one disables the reading and restoration of the drive LBA during a REASSIGN BLOCKS command. If DRRT is zero, the REASSIGN BLOCKS command attempts to restore the drive LBAs data for reassignment. If the data cannot be restored, a data pattern of all 00's is used. ! FFMT (Fast Format Enable) of one allows the formatting of the drive without writing to the customer data area. All format operations are allowed including changing block sizes and manipulating defects. Fast Format operation assumes an data initialization is done later. Read operation without the data initialization may cause unrecoverable read errors. ! FCERT (Format Certification) of one specifies the certification will be performed during a FORMAT UNIT command. A FCERT of zero disables the certification. ! IRT (Integration Reassign Threshold) of one specifies the use of lower thresholds for reporting recovered errors and auto reallocation for READ and WRITE commands for the manufacturing test phase of system. When IRT is set to zero, the default thresholds are used. ! IVR (Integration Verify Recovery) of one specifies the use of lower thresholds for reporting recovered errors for VERIFY commands for the manufacturing test phase of system. When IVR is set to zero, the default threshold is used. Ultrastar 146Z10 hard disk drive specifications 87
![](/manual_guide/products/ibm-ic35l036uwdy10-hard-drive-specifications-4359dfe/103.png)