IBM IC35L036UWDY10 Hard Drive Specifications - Page 167
REQUEST SENSE 03h, Reserved = 0, VU = 0, Allocation Length, Command Code = 03h
UPC - 000004119524
View all IBM IC35L036UWDY10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
8.28 REQUEST SENSE (03h) Byte 0 1 2 3 4 5 Bit 7 6 5 4 3 2 1 0 Command Code = 03h Reserved = 0 Reserved = 0 Reserved = 0 VU = 0 Allocation Length Reserved = 0 FLAG LINK Figure 151. REQUEST SENSE The REQUEST SENSE command requests the drive to transfer sense data. The sense data shall be available under the following conditions: ! The previous command to the specified I_T_L nexus4 terminated with CHECK CONDITION status. All other information (e.g. medium position) is available in any fields. ! The previous command to the specified I_T_L nexus ended unexpected BUS FREE error. If REQUEST SENSE command with an invalid LUN is received, the drive returns GOOD status and reports a sense key of ILLEGAL REQUEST and an additional sense code of LOGICAL UNIT NOT SUPPORTED. If the drive has no sense data available to return, it shall return a sense key of NO SENSE and an additional sense code of NO ADDITIONAL SENSE INFORMATION. The sense data shall be preserved by the drive for the initiator until retrieved by the REQUEST SENSE command or until any other command for the same I_T_L nexus. Sense data shall be cleared upon receiving a subsequent command including REQUEST SENSE to the same I_T_L nexus. Separate sense data is maintained by the device for each initiator. Therefore, there is no requirement for an initiator to expeditiously clear a CHECK CONDITION as this will not affect other initiators in a multiinitiator system. The drive will return the number of bytes in the allocation length or 32 bytes whichever is less. The contents of the sense data is defined in Section 12.0, "SCSI Sense Data" on page 215. 4 A nexus which exists between an initiator, a drive, and a logical unit. Ultrastar 146Z10 hard disk drive specifications 151