IBM IC35L036UWDY10 Hard Drive Specifications - Page 74
Organization for Standardization ISO version of SCSI ISO DP 9316., Refer
![]() |
UPC - 000004119524
View all IBM IC35L036UWDY10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
! ISO is set to zero to indicate that this drive does not claim compliance to the International Organization for Standardization (ISO) version of SCSI (ISO DP 9316). ! ECMA is set to zero to indicate that this drive does not claim compliance to the European Computer Manufacturers Association (ECMA) version of SCSI (ECMA-111). ! ANSI indicates the level of the ANSI standard that is supported by the drive. The drive supports ANSI SCSI version 3. ! TrmTsk (Terminate Task) filed of 0 indicates the drive does not support the TERMINATE TASK task management function as defined in the SAM. ! NormACA (Normal ACA) field of 0 indicates the drive does not support setting the NACA bit to one in the Control Byte of the CDB as defined in the SAM. ! Response Data Format is set to two to indicate that the Inquiry Data Format as specified in ANSI SCSI version 2 is supported by the drive. ! Additional Length indicates the number of bytes of inquiry information that follows. ! EncSer (Enclosure Services) bit of 0 indicates that the drive does not contain an embedded enclosure service component. ! MultiP (MultiPort) bit of 0 indicates that the drive has a single port and does not implement multi- port requirements. ! MChngr (Medium Changer) bit is only supported when the RMB bit is one. ! ACKREQQ (ACKQ/REQQ) bit of 0 indicates that the drive does not support a request and acknow- ledge data transfer handshake on a Q cable. ! Addr32 (Wide SCSI Address 32) bit of 0 indicates that the drive does not support 32 bit wide SCSI Addresses. ! Addr16 (Wide SCSI Address 16) bit of 1 indicates that the drive supports 16 bit wide SCSI Addresses. ! REL_A is set to zero to indicate that the drive does not support 'Relative Address Mode'. ! Wb_32 is set to zero to indicate that the drive does not support 32-bit wide data transfers. ! Wb_16 is set to one to indicate that the drive supports 16-bit wide data transfers. ! Sync is set to one to indicate that the drive supports synchronous data transfer. ! Link is set to one to indicate that the drive supports linked commands. ! TTD is set to zero to indicate that the drive does not support the CONTINUE I/O PROCESS and TARGET TRANSFER DISABLE message for this logical unit. ! CmdQu is set to one to indicate that the drive supports command queuing. ! Vendor ID is 'IBM' padded with ASCII blanks. ! Product ID is specified in ASCII characters. Refer to Section 4.3.1, "Product ID" on page 10. ! Product Revision Level indicates the level of microcode. It indicates RAM microcode level. ! Unit Serial Number contains the drive serial number. ! Clocking 11b indicates the drive supports ST (Single Transition) and DT (Double Transition) on synchronous transfer. ! QAS (Quick Arbitrate Supported) bit of one indicates that the drive supports the quick arbitrate feature; a bit of zero indicates that the drive does not support the quick arbitrate feature. ! IUS (Information Unit Supported) bit of one indicates that the drive supports information unit; a bit of zero indicates that the drive does not support information unit. Ultrastar 146Z10 hard disk drive specifications 58
![](/manual_guide/products/ibm-ic35l036uwdy10-hard-drive-specifications-4359dfe/74.png)