Intel S1200RP Technical Product Specification - Page 48
Drive Hot
View all Intel S1200RP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
System Storage and Peripheral Options Intel® Server System R1000RP Family TPS 5.2.1 3.5" Drive Hot-Swap Backplane Overview On the front side of each back plane are mounted four hard disk drive interface connectors (A), each providing both power and I/O signals to attached hard disk drives. Figure 31. The Front Side of 4 x 3.5" Hot Swap Backplane On the backside of each backplane are several connectors. The following illustration identifies each. Label A B C D Description 7-pin SATA/SAS I/O connectors SMBus*-In cable connector - From Server board SGPIO connector Power connector Figure 32. The Back Side of 4 x 3.5" Hot Swap Backplane A - 7-pin SATA I/O Connectors: The backplane has four 7-pin SATA/SAS I/O connectors, one for each hard drive. A single multi-connector cable is routed from the backplane to a four port mini-SAS connector on the server board or other optionally installed SATA/SAS host bus adapter. B - SMBus* Cable Connectors: The backplane includes a 1x5 cable connector used as a management interface to the server board. C - SGPIO Cable Connector: The SGPIO connector is a management interface used to control the hard drive fault LEDs on the backplane. The SGPIO signals are routed through a multiconnectors cable that is routed to a four port mini-SAS connector on the server board or other optionally installed SATA/SAS host bus adapter. D - Power Harness Connector: The backplane includes a 2x2 connector supplying power to the backplane. Power is routed to the backplane through a power cable harness from the server board. 38 Intel order number: G91532-003 Revision 1.2