Intel SC450NX Product Guide - Page 196

FRUSDR load utility, 31, 69 when to run, 69 G - H gasket, EMI protection at I/O connectors, 111 grounding clip, removable media drives, 99 hard disk drive hot-swapping, 80 plastic carrier, 79 SCSI, 79 using fans for high-power drives, 106 using heatsinks on high-power drives, 82 Hard Drive submenu, configuring, Setup, 44 heatsinks, on high-power drives, 82 high-power drives when to use fans, 106 when to use heatsinks, 82 hot key option, quick reference, 31 I I/O address, 154 ISA expansion slots, 19 PCI expansion slots, 19 ports provided, 19 I/O Device Configuration submenu, configuring in Setup, 39 IDE bus length limit, 26 cable considerations, 97 cable, must disconnect to reuse interrupt, 97 connectors on baseboard, 100 controller, 26 primary, master and slave, configuring, Setup, 36 indicators, removing front panel control board, 94 input voltage, 17 installing termination board, 118 internal bay, size and capacity, 16 interrupt mapping, 157 must disconnect IDE cable to reuse interrupt, 97 intrusion detection, 27, 28 IPMB for monitoring status, 27 ISA connectors on baseboard, 149 embedded device support, 19 expansion slots, 19 feature summary, 24 installing add-in board, 92 removing add-in board, 93 run SSU after installing or removing add- in board, 93 J - K jumpers CMOS clear, 151 do not damage when changing, 110 location on baseboard, 151 password, 151 recovery boot, 151 keyboard compatibility, 26 connector at back panel, 14 features, configuring, Setup, 37 lockout timer, setting in SSU, 26 L language, changing in BIOS, 76 lithium backup battery disposing of safely, 120 installing, 121 removing, 120 M main power supply, connector, 139 memory, 22 addresses, 23 amount installed, 19 amount tested, POST, 32 as used by different operating systems, 23 base amount, 23 capacity, 19 extended region, 23 installing DIMM, 114 installing memory module, 113 physical, 23 removing DIMM, 113 removing memory module, 112 196