JVC EX A10 Instructions - Page 11

Introduction Operating the TV using the remote control You can operate your TV using the remote control of this system. TV CHANNEL Remote control mode selector F TV TV/VIDEO TV VOLUME ENTER Number buttons Setting the manufacturer code 1 Slide the remote control mode selector to TV. 2 Hold down F TV. • Hold down F TV until you finish step 4. 3 Press ENTER and release. 4 Press number buttons (1-9, 0). • Refer to "Using the number buttons" (A page 15). Examples: For a Hitachi TV: Press 1, then 0. For a Toshiba TV: Press 0, then 8. When the manufacturer of your TV has two or more codes, select the manufacturer codes in turn and find the one that operates the TV and the remote control properly. Manufacturer Code JVC 01 Hitachi 10 Magnavox 02 Mitsubishi 03 Panasonic 04, 11 Philips 14 RCA 05 Manufacturer Samsung Sanyo Sharp Sony Toshiba Zenith Code 12 13 06 07 08 09 NOTE • A manufacturer code is subject to change without notice. You may not be able to operate the TV produced by the manufacturer. 5 Release F TV. Using the remote control for the TV operation Operate the remote control by pointing it at the TV. Turns on/off the TV. Changes the channels. Adjusts the volume. ~/ / Selects the channels. Switches the *1 previously selected channel and the current channel. Switches the TV and video input. *1 Make sure to slide the remote control mode selector to TV in advance. NOTE • After replacing the batteries of the remote control, set the manufacturer code again. • When the remote control mode selector is slid to TV, some buttons may not work. 6