JVC EX A10 Instructions - Page 46

Listening to the sound of other audio equipment Listening to the sound of other audio equipment MEMORY Remote control mode selector AUX 3 (play) Adjust the sound input level of the audio equipment You can adjust the sound input level of audio equipment connected to the AUX terminals. 1 Slide the remote control mode selector to RECEIVER. 2 Press AUX to select "AUX". • Each time you press AUX, the display on the receiver toggles between "AUX-DIGITAL" and "AUX". • The source changes to the signal from the AUX terminals. 3 Hold down MEMORY until the input level is displayed. • Each time you hold down the button, the input level switches as follows: LEVEL1 STORED: For normal use. (initial setting) Connect the other audio equipment to this system in advance (A page 12). 1 Slide the remote control mode selector to RECEIVER. 2 Press AUX to select "AUX-DIGITAL" or "AUX". • Each time you press AUX, the display on the receiver toggles between "AUX-DIGITAL" and "AUX". • The source changes to the signal from the AUX terminals. • You can also use SOURCE SELECT on the receiver to select the signal from the AUX terminals as the sound source. 3 Begin playback on the other audio equipment. • For details on beginning playback, refer to the manual of the connected equipment. 4 Adjust the volume and the sound quality of the system (A page 16). 41 NOTE • When no equipment is connected to the DIGITAL IN AUX terminal or the power of the connected equipment is off, after "AUX-DIGITAL" is selected, the display changes to "AUX-D UNLOCK". LEVEL2 STORED: To correct distorted sound caused by an extremely high input level from other equipment.