Kenwood TS-480HX Operation Manual - Page 14
Panel And Microphone Connection, Panel And Microphone Connection Using Pg-4z Option
![]() |
View all Kenwood TS-480HX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1 INSTALLATION PANEL AND MICROPHONE CONNECTION Plug the microphone plug to the MIC jack (8-wire/ RJ45), then connect the Remote Control panel to the TX/ RX unit with the supplied cable (2 m/ 6-wire/ RJ11). Microphone To MIC EXT.SP DATA REMOTE MIC PANEL COM 3cm PADDLE KEY To PANEL Line filter PANEL AND MICROPHONE CONNECTION USING PG-4Z (OPTION) Use the cables and connectors to connect the Remote Control panel and TX/ RX unit with the PG-4Z cable kit as shown below. Extension adaptor (RJ45) from the PG-4Z cable kit Extension cable (RJ45) from the PG-4Z cable kit PANEL EXT.SP DATA REMOTE Cable holder Line filter (large) from the PG-4Z cable kit Line filter (small) from the TS-480 To MIC MIC 3 cm PANEL EXT.SP DATA REMOTE COM PADDLE KEY 3 cm To EXT.SP To external speaker 1 cm Line filter (small) from the PG-4Z cable kit Extension cable (RJ11) from the PG-4Z cable kit External speaker extension cable from the PG-4Z cable kit (when the external speaker is used) Extension adaptor (RJ11) from the PG-4Z cable kit Tapping screw (4 mm x 14 mm) Flat washer Microphone cable RJ45 (8-wire) adaptor Double-sided adhesive tape 6
![](/manual_guide/products/kenwood-ts480hx-operation-manual-0dc4080/14.png)