Kenwood TS-480HX Operation Manual - Page 21
Lcd Display
View all Kenwood TS-480HX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
LCD DISPLAY 3 GETTING ACQUAINTED q w e r t y u i o !0 !1 !2 !3 !4 !5 !6 !7 !8!9 q METER While receiving, serves as an S-meter to measure and display the received signal strength. While transmitting, serves as a power meter plus an ALC meter, an SWR meter, or a Speech Processor compression meter. The Peak Hold function holds each reading for approximately half a second. w RtATsT Appears while the internal antenna tuner {page 60} or an external antenna tuner is in-line for the operation. e 1tANTs2 Either "1tANT" or "ANTs2" appears, depending on which antenna connector is selected for the operation {page 60}. r ATT Appears when the receiver's attenuator (approx. 12 dB) is ON {pages 49, 61}. t PRE Appears when the receiver pre-amplifier (approx. 6 dB) is ON {page 49}. y VOX Appears when the VOX (Voice Operated Transmission) function is ON or the Break-in function is ON for the CW mode {pages 36, 39}. u PROC Appears when the Speech Processor function is ON {page 37}. i MENU Appears when configuring the parameters in the Menu mode {page 22}. o Reserved for future updates. !0 Appears while the Constant Recording function is working {page 69}. !1 NB Appears when the Noise Blanker is ON {page 47}. !2 AGC OFF "AGC - F" (fast) or "AGC" (slow) appears when the AGC (Automatic Gain Control) function is ON. "AGC OFF" appears when the AGC is OFF {page 35}. !3 NAR 2 "NAR" appears when the narrow IF filter is selected for the operating mode. If 2 optional IF filters are installed and the transceiver selects the secondary IF filter, "NAR 2" appears {page 45}. !4 MHz Appears when the MHz Up/ Down mode using the MULTI control is ON {page 34}. It also appears when the Quick Menu function is ON {page 22}. !5 FINE Appears when the Fine function is ON {page 35}. !6 Appears when the selected Menu No. is in the Quick Menu list. It also appears when the transceiver is scanning the frequencies between the slow down frequency points {page 57}. !7 Appears when the split-frequency operation is ON {page 30}. !8 Appears when the Tuning control Lock function is ON {page 63}. !9 Appears when the Frequency Lock function is ON {page 63}. 13