Kenwood TS-480HX Operation Manual - Page 80
Operator Conveniences, Dx Packetcluster Tune
View all Kenwood TS-480HX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
13 OPERATOR CONVENIENCES DX PACKETCLUSTER TUNE If you have a TM-D700, you can connect it to the TS480 transceiver to use the DX PacketCluster Tune function. Connect the 2 transceivers with a crosswired DB-9 cable as shown on page 79. 1 Press [MENU/ F.LOCK] and turn MULTI control to select Menu No. 56 on the TS-480 transceiver. 2 Press [ ]/ [ ] to select the same communication baud rate that the TM-D700 transceiver is configured. 3 Tune to the DX PacketCluster node frequency on the TM-D700 transceiver. 4 Press [F] (1 s), [TNC] on the TM-D700 transceiver. • "TNC APRS" appears on the TM-D700 display. 5 Press [F] (1 s), [DX] on the TM-D700 transceiver. • Every time the DX station's information is reported to the DX PacketCluster node, the TM-D700 stores and list the report to the memory. 6 Select a desired DX station data with [c]/ [d] on the TM-D700 transceiver. 7 Press [MHz] on the TM-D700 to transfer the frequency data to the TS-480 transceiver. • If the transferred frequency data is available on the TS-480 transceiver, the frequency data will be overwritten to the current operating frequency. Otherwise, the operating frequency of the TS-480 transceiver remains unchanged. For more detailed operation on the DX PacketCluster operation of the TM-D700 transceiver, refer to page 6 of the TM-D700 instruction manual (Specialized Communications). Note: ◆ Refer to the respective instruction manuals of the TH-D72/ TM- D710/G, or RC-D710 for information on how to connect, configure, and operate the transceivers for DX PacketCluster Tune function. ◆ The firmware of the TM-D700 transceiver must be version G2.0 or later to use the DX PacketCluster Tune function. 72