Kyocera ECOSYS FS-1120D DRIVER DOWNLOAD Kyocera Command Center RX User Guide R - Page 45

Function Settings Fax Settings 1. Click FAX/i-FAX under Function Settings on the navigation menu. The FAX/i-FAX Settings page opens. 2. You can configure settings for General. Make the following settings: 1. Local FAX Number: Specifies your FAX system number. 2. Local FAX ID: Specifies your FAX ID. 3. Speaker Volume: Sets the volume of the internal speaker that allows you to listen to the other party or to verify the conditions on the telephone line when the OnHook key was pressed. Select the speaker volume from 0 (Mute) to 5 (Maximum). 4. Monitor Volume: Sets the volume of the internal speaker that allows you to verify the FAX tones during FAX communication. Select the speaker volume from 0 (Mute) to 5 (Maximum). 3. You can configure settings for Transmission. Make the following settings: 1. Dialing Mode: According to the type of telephone line you are contracted with, select Tone (DTMF), Pulse (10PPS), or Pulse (20PPS). 2. TX Start Speed: Selects the speed rate at starting transmission from 33600bps, 14400bps, and 9600bps. Once communication is established, the speed rate that is slower than the other is employed. 3. ECM TX: Turns error correction mode on which corrects errors that may happen during communication. To let the ECM feature to take effect, error correction mode must be enabled on both parties in prior. 4. You can configure settings for Reception. Make the following settings: 1. FAX Receive: Selects the FAX reception mode. The choices are Auto (Normal, FAX/Tel, TAD or DRD) or Manual. (The selectable option is different depending on the destination.) 2. Number of Rings (Normal): Specifies the number of rings when FAX Receive is Auto (Normal). The range is 1 to 15. 3. Number of Rings (FAX/Tel): Specifies the number of rings when FAX Receive is Auto (FAX/Tel). The range is 0 to 15. 4. Number of Rings (TAD): Specifies the number of rings when FAX Receive is Auto (TAD). The range is 1 to 15. 5. Remote Switching Dial Number: Specifies the FAX remote switching dial number. The range is 00 to 99. Remote switching allows you to initiate FAX reception from a telephone connected to the FAX system. 6. Encryption Key No.: Sets the encryption key number used for encrypted communication. 7. RX Start Speed: Selects the speed rate at starting reception from 33600 bps, 14400 bps, and 9600 bps. Once communication is established, the speed rate that is slower than the other is employed. 8. ECM RX: Turns error correction mode on which corrects error that may happen during communication. To let the ECM feature to take effect, error correction mode must be enabled on both parties in prior. 5. You can configure settings for Encryption Key. Make the following settings: 1. Encryption Key Registration: Click Settings button. The Encryption Key Registration page opens. Specifies the encryption key in hexadecimal. The length of the encryption key is 16 digits. Enter the encryption key including the numbers 0-9 and the letters A-F. 2. Click Submit button. 6. You can configure settings for Remote Settings. Make the following settings: User Guide 41